May 14, Reference ASTM D, ASTM D, Methods A & B. Package Weight ≤ 91 kg [ lb]. (Sample Size < 9). Procedure. 1. Raise package to. Nov 1, ASTM D_能源/化工_工程科技_专业资料。Designation: D – 97 AMERICAN SOCIETY FOR TESTING AND MATERIALS Barr. Apr 30, ASTM D Test Method for Random Vibration Testing of Shipping Containers, .. TEST PROCEDURE: ASTM D TEST METHOD A.
|Published (Last):||20 February 2012|
|PDF File Size:||3.10 Mb|
|ePub File Size:||19.13 Mb|
|Price:||Free* [*Free Regsitration Required]|
The impact should be made at twice the specified height. As the voice of the U.
The SI units given in parentheses d61779 for information only. With a possible test weight up to kilo and a table surface of 2.
ASTM testing – Technicas
Where test items are tall or top heavy, provision must be made to prevent the test item from tipping over after the drop is made. Normally, Test Methods A and B are not applied to unitized loads. For the designation of the faces referred to in the tables, see Test Method D Standard test method for rough handling of unitized loads and large shipping cases an crates.
Normally, Test Methods A and B are not applied to unitized loads. Such a pretest minimizes any risks and may even be a cost advantage. Additional tests that apply to mechanical handling of unitized loads and large cases and crates include incline impact tests, described in Test Method D and horizontal impact tests, described in Test Methods D and Test Method D The drop should be in the impact orientation most likely for a drop to occur, usually the largest face or the bottom. We have no amendments or corrections for this standard.
These test methods are applicable to common means of material handling as follows: Release the test item and allow to fall freely.
Historical Version s – view previous versions of standard. There is a problem adding monitoring – please try again later There is a problem adding the subscription – please try again later. Load the test item with the actual contents for which it was designed. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.
During transport by aircraft, ship and during long truck journeys, packaging have the chance of damage caused by stacking, pressure, humidity, brake movement and vibrations.
This is often a cumbersome, expensive and rather unreliable way of testing. The data from the data recorder will be used after analysis and operation for the control of the vibration table.
Your comments will receive careful consideration at a meeting of the responsible technical committee, which you may attend. The test applies to design types for IBC’s manufactured after 31 December This standard is subject to revision at any time by the responsible technical committee and must be reviewed every?
ASTM D6179 – 07(2014)
These are lighter than wood boxes or crates. Very thin lumber is used for a wirebound box. These test methods are applicable to common means of material handling as follows Subscription pricing is determined by: Not all of the test methods are applicable to astn products, containers, and loads.
This labo test gives you a reliable and respective alternative to the so-called transport test which companies do themselves. D Terminology of Packaging and Distribution Environments.
Where this test is performed to satisfy a regulatory or contractual requirement, its use is subject to approval by the agency concerned. Optimizations or improvements of existing packaging and products in a controlled manner d6197 be easily implemented and tested against the measured transport.
If use of actual 4 contents is not practical, a dummy load of the same total mass, size, and weight distribution may be substituted.